Hayward Aqua Rite Pro AQ-RT-PRO prior to Oct 08 - Page 20
Goldline Aqua Rite Chlorinator - sense and dispense
View all Hayward Aqua Rite Pro manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Goldline Aqua Rite Chlorinator The Aqua Rite Pro can control one or more Goldline Aqua Rite chlorinators when additional sanitizing capacity is required. A 4 wire connection is used to communicate to the Aqua Rite(s) and can be wired up to 500' apart. Any outdoor rated 4 conductor cable can be used. Refer to the wiring diagram below and on the following page for proper wiring connection to the Aqua Rite. NOTE: There must be only 1 "primary" unit. All other Aqua Rite units must be configured as "secondary". The Aqua Rite(s) power input must be wired to the LOAD SIDE of the filter pump timer (the same as the Aqua Rite Pro). Jumper Installed For Primary (Factory Default) 4 GREEN 3 YELLOW 2 BLACK 1 RED Jumper Removed For Secondary(s) Aqua Rite Pro Aqua Rite (Primary) Aqua Rite (Secondary) Additional Aqua Rite(s) (if required) Aqua Rite Pro RED 1 BLK 2 YEL 3 GRN 4 NOTE: Primary/Secondary jumper is located underneath small circuit board. green yellow black red 4 GRN 3 YEL 2 BLK 1 RED Aqua Rite Optional pH Dispense Wiring Requires the use of a Goldline AQL-CHEM sensing device and an AQL-CHEM2, AQLCHEM2-240 or other pH dispensing device requiring 120VAC or 240VAC on/off control. A screw terminal block located on the enclosure surface below the transformer is provided for connection to an AQL-CHEM2, AQL-CHEM2-240 or other pH related dispensing device (peristaltic pumps, solenoid valves, etc.). After properly installing and configuring the AQL-CHEM and the ph dispensing device, the Aqua Rite Pro will turn on the dispensing device when pH correction is required. IMPORTANT: The dispensing device must be powered by the same voltage used to power the Aqua Rite Pro. Configure the output voltage to the pH device by moving the wiring connections on the mainboard as shown on page 18. Example: If an AQL-CHEM2-240 (240VAC) will be used, the Aqua Rite Pro must be powered by 240VAC. Connect the 240VAC pigtail supplied with the AQL-CHEM to the Aqua Rite Pro's terminal block as shown in the diagram. The AQL-CHEM2-240 will then plug into the pigtail's 240VAC receptacle. Refer to the AQL-CHEM manual for more detailed information. 17