Hayward Booster Pump Model 6060 - Page 5
Installation Instructions, WARNING - 6060
View all Hayward Booster Pump manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
6060 Booster Pump Product Specifications Page 5 of 16 Installation Instructions WARNING - This product should be installed and serviced only by a qualified professional. Pump Location Pressure Cleaner Locate booster pump as shown in above diagram and run suction lines as direct as possible to reduce friction loss. Suction lines should have continuous slope upward from lowest point in line. Joints must be tight (but not over-tightened). Suction line diameter must equal or be larger than the discharge line diameter. Though the pump is designed for outdoor use, it is strongly advised to place pump in the shade to shield it from continuous direct heat. Select a well-drained area that will not flood when it rains. Do NOT install pump in a damp or non-ventilated location. Keep motor clean. Pump motors require free circulation of air for cooling. Pump Mounting Install pump on a level concrete slab or other rigid base to meet all local and national codes. Secure pump to base with screws or bolts to further reduce vibration and stress on pipe or hose joints. The base must be level, rigid, and vibration free. Pump mount must: Allow pump inlet height to be as close to water level as possible. Allow use of short, direct suction pipe (to reduce friction losses) and gate valves in suction/discharge piping. Be protected from excess moisture and flooding, and allow adequate access for servicing pump and piping. WWW.HAYWARDPOOL.COM USE ONLY HAYWARD GENUINE REPLACEMENT PARTS