Hayward HCC 4000 HCC4000 Series Manual - Page 27

Store sensors in the soaking caps provided, making sure that each container is filled with the original storage solution or clean water. If the storage containers have been misplaced, store sensors individually in small glass or plastic containers with clean water covering sensor tips. Controller Storage The controller unit is subject to damage by electro-static discharge (ESD) when the sensor cables are disconnected. Always reinstall the BNC protective covers prior to storing or transporting the HCC 4000 controller unit. Winterization The sensors should be prepared for storage as outlined above and protected from freezing temperatures. Although the HCC 4000 controller is designed to withstand a broad temperature range, winter storage in a secure location may be desirable. The flow cell and poly tubing must be drained prior to exposure to freezing temperatures. Either purge all water using compressed air or thoroughly drain through the valve ports and tubing connections. Network Communications Cell and Satellite All CAT controllers set up on Cell and Satellite networks come already activated for wireless communication. Once the unit has been installed and registered on www.poolcomm.com, the devices will begin to communicate. Local reception and antenna positioning can affect communication capability, if the unit does not communicate please call 301-838-4001 and ask for technical support. WIFI WIFI Controllers communicate via local WIFI networks. Before these units can begin to communicate, they must be configured to connect to the local WIFI network. Please consult the WIFI Connectivity Checklist also included for technical information and see WIFI Connectivity Setup included. Test w/ a HCC 4000 The best way to check for coverage at a facility is to test with an actual HCC 4000. The Transmit data button has been provided specifically for this purpose. Place the HCC 4000 unit where you expect to install it and press the transmit data button. Within 2 minutes a service request alarm will be generated. This alarm will show up at the POOLCOMM web site, and can also be directed to your cell phone or portable 2-way device. Make sure your email address has been entered under Notifications and that address box is checked on the unit management page. 26 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS