Hayward MaxFlo VS 500 Omni VS Omni Automation Control Installation Manual - Page 23

System Startup After confirming that all wiring has been performed according to NEC and local codes and that the Hub is properly grounded, apply power to the VS Omni. The VS Omni will take about 30 seconds to fully start. Firmware Upgrade The VS Omni's firmware is the basic operating system that runs the system. The VS Omni was shipped with the version of firmware that was available at the time of release. There may be a newer version available and if so, we encourage you to upgrade. Also, if you have experienced problems, Hayward Technical Support may advise you to upgrade your VS Omni's firmware. To upgrade the VS Omni firmware, refer to the procedure shown in the VS Omni Operation Manual. Upgrading firmware can be performed before or after Configuration but should be done before the VS Omni begins operation. Configuration Initial Configuration Because this is the first time that the VS Omni has been powered on, it will bring you directly to the initial configuration screen shown below. Note that the VS Omni Control Pad uses a resistive touch screen that is appropriate for a pool environment. It requires a deliberate push when selecting a button. At the initial configuration screen, touch the "en" button to select a language (the default language is English) and then touch "OK" to begin configuration. After pressing "OK" you will be prompted to select the type of configuration wizard that you would like to use as shown below. See the descriptions in the "About the Configuration Wizard" section for information about each type of configuration wizard so that you can choose the right one to fit your needs and make configuration as simple as possible. Welcome to the Hayward Pool Controller Press OK to con gure your pool. OK en Pre Programmed Config (VSP, Htr, Lt) New Typical Configuration New Advanced Configuration Load Existing Configuration System Options SYSTEM configuration 22 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS