Hayward MaxFlo VS Max-Flo VS™ Manual - Page 15
Quick Speed Change
View all Hayward MaxFlo VS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Screen Buttons Used ▲▼ DISP/FUNC Comments Adjust the motor rpm of V1 Move to the next selection ▲▼ DISP/FUNC Adjust the motor rpm of V2 Move to the next selection ▲▼ DISP/FUNC Adjust the timer of V2 Move to the next selection ▲▼ DISP/FUNC ▲▼ DISP/FUNC Adjust the motor rpm of V3 Move to the next selection Adjust the timer of V3 Exits the menu and saves all changed settings Note: When entering into configuration mode, the LED for the speed being configured will FLASH. When completely exited from configuration mode the LED for the speed that was currently running will illuminate. If configuration mode is not completely exited after 2 minutes, the controller will save all settings excluding the current screen settings and exit configuration mode. Note: The maximum allow speed for speeds V1 through V3 is 3,000 RPM. The minimum allowable speed for V1 through V3 is 600 RPM. The maximum allowable time for speeds V2 and V3 is 23 hours and 30 Minutes. The minimum allowable time for speed V2 and V3 is 30 Minutes. 6.7. Quick Speed Change Screen Buttons Used Comments Press ▲ or ▼ to change the current ▲▼ running speed ▲ and ▼ Press ▲ and ▼ to save the new speed setting over the currently running speed Note: When a quick speed change is performed the LED for the changed speed will FLASH. If the new speed setting is saved by PRESSING ▲ and ▼, the LED for that speed will illuminate solid. If the new speed setting is not saved, the pump will continue to run at the changed speed until the timer runs out for that speed or the speed is changed again. The LED for the changed speed will FLASH as long as a modified speed is running and has not been saved. Page 15 of 24 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Max-Flo VS Pump IS2300VSP Rev C