Hayward Pro Logic® Model: PL-PS-4 PL-PS-8 PL-PS-16 PL-PS-16V Operation - Page 44
Spa Filter VSP Drive Comm Error
View all Hayward Pro Logic® manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
• PS-16 Communication Error -- If an PL-PS-16 and the Expansion Unit is not responding. • Low Volts -- If the chlorinator cell voltage is too low. • No Cell Power -- If no chlorinator cell power is detected on the printed circuit board. • Chk Flow Switch -- If the flow switch input is invalid. • Cell Power Error -- If a chlorinator cell power error is detected on the printed circuit board. • No Flow-Filter Pump -- If the filter pump is on and the flow switch indicates no flow for 15 minutes or more. • Cell Missing -- If the chlorinator is enabled but no cell is detected. • Pool Filter VSP Comm Error-- If variable speed is selected for the Pool Filter and the Hayward VSP interface is not responding. • Pool Filter VSP Drive Comm Error -- If variable speed is selected for the Pool Filter and the Hayward VSP drive controller is not responding. • Pool Filter VSP Err: x -- If variable speed is selected for the Pool Filter and the Hayward VSP is indicating and error. x is the same decimal error displayed by the VSP itself. • Spa Filter VSP Comm Error -- If variable speed is selected for the Dual Equipment Spa Filter and the Hayward VSP interface is not responding. • Spa Filter VSP Drive Comm Error -- If variable speed is selected for the Dual Equipment Spa Filter and the Hayward VSP drive controller is not responding. • Spa Filter VSP Err: x -- If variable speed is selected for the Dual Equipment Spa Filter and the Hayward VSP is indicating and error. x is the same decimal error displayed by the VSP itself. • Aux1 VSP Comm Error -- If variable speed is selected for the Aux1 relay type and the Hayward VSP interface is not responding. • Aux1 VSP Drive Comm Error -- If variable speed is selected for the Aux1 relay type and the Hayward VSP drive controller is not responding. • Aux1 VSP Err: x -- If variable speed is selected for the Aux1 relay type and the Hayward VSP is indicating and error. x is the same decimal error displayed by the VSP itself. For Pool Filter, Spa Filter and Aux using Gen2 EcoStar Variable Speed Pumps only: • Main Voltage is too low • Main Voltage is too high • Remote Stop was pressed (Press "+" to restart) • Prime Failed (Press "+" to restart) • Failed to start (Press "+" to restart) • Pump has stalled (Press "+" to restart) • SVRS tripped (Press "+" to restart) • Drive failure (see Pump Display) • CSM Comm Error: -- If Chemistry Sensing is enabled and the Chemistry Sense Module (CSM) is not responding. • pH Probe Error -- If the CSM indicates that there is a problem with the pH probe. • pH Low - Check Feeder -- If a pH level of 6.9 or less is detected, check the feeder for proper operation • pH High - Check Feeder -- If a pH level of 8.1 or higher is detected, check the chemical supply and the feeder for proper operation 41