Hayward RC9740CUB Robotic Cleaners Troubleshooting Guide - Page 43
Bubbles Through the Exit Venturi
View all Hayward RC9740CUB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Troubleshooting Will not climb walls Confusion on normal operation • The startup of each 4 hour cycle may require up to 30 minutes as the machine measures the pool configuration before climbing the walls completely to the water line. • During the 4 hour cycle the machine will randomly re-measure the pool configuration or release itself from the wall. The machine will not climb the walls during this 15-30 minute cycle. Climbs Too High, Falls off Wall at Waterline, Blows Air Bubbles Through the Exit Venturi • Above average traction in a clean pool. Install the Restrictor Plate Kit RCX11206 in the venturi. • Inspect bottom lid filter plate gasket and replace if torn or missing. • Set handle position at an angle, machine should never operate with the handle in the center or straight position. • Check water chemical balance. Page 40