Hayward Salt & Swim® 3C Salt & Swim Owner's Manual - Page 14

Operation Controls The main controls and indicators are shown below. Illuminates when Cell has reached the end of its expected life. When this LED indicator is illuminated, there is a problem with the unit. Refer to the Troubleshooting section of this manual. Illuminates when unit is waiting for the filter pump to turn on or is in-between generating cycles as part of normal operation to maintain selected DAILY CHLORINE OUTPUT. Illuminates when unit is actively generating chlorine. Illuminates when unit is SUPER CHLORINATING. Illuminates when there is no flow or low flow through the Cell. The pool filter pump could be in its "off" cycle. If this is not the case, refer to the Troubleshooting section in this manual. Blinks when performing the Flow Switch Calibration procedure. Press ( + ) and ( - ) to increase or decrease the chlorine generation. The DAILY CHLORINE OUTPUT LEDs above these buttons will indicate the relative amount of chlorine being generated. When you have an abnormally high bather load, a large amount of rain, a cloudy water condition, or any other condition which requires a large amount of purification to be introduced, press the SUPER CHL ORINATING button. This electronically "super chlorinates" (boosts chlorine generation output) the water for 24 hours (filter pump must be on during this time). To cancel super chlorinating, press the SUPER CHLORINATING button again. 12 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS