Hayward SharkVAC Model: RC9740 RC9742 - Page 10
Do Not Enter The Swimming Pool When The Sharkvac Is Operating.
View all Hayward SharkVAC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Should a second cleaning cycle be required, switch OFF the power supply for 10 seconds and restart. 7. After the pool has been cleaned, switch OFF the power supply before removing the SharkVAC from the pool. 8. Remove the SharkVAC from the water at the shallow end of the pool by pulling the cable until the SharkVAC reaches the surface. Then lift it out of the water using the handle, NOT the cable. 9. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. Caution: When pulling the cable, reel it in hand-over-hand - do NOT reel it around your arm. DO NOT ENTER THE SWIMMING POOL WHEN THE SharkVAC IS OPERATING. Optimum operating water temperature range for the SharkVAC is 50F - 95F (10ºC á 35ºC). Remove the SharkVAC from the pool after each use. Keeping the SharkVAC permanently in the pool may result in additional service requirements. 10