Hayward Universal CrystaLogic Pool & Spa Lights Universal ColorLogic and Cryst - Page 2

STEP 5: Snake Cord through Conduit Pull at the junction box or transformer end to snake the Universal ColorLogic/CrystaLogic cord through the conduit. Leave slack at the light end for coiling cord in the niche. The coil length should be adequate for placing the light on the deck if pool servicing ever requires light removal. Some niches may have an 8AWG connection from the junction box to the niche. If so, ensure that this connection is not interrupted when installing the new light. Replacing 120 volt pool or spa lights with Universal ColorLogicTM or CrystaLogicTM STEP 6a: Install Light to most Niches To fasten the Universal ColorLogic/CrystaLogic light to most niches refer to the diagram below. STEP 56:bI:nsInesrttaClleLllight to Pentair Niche For Pentair® niches, use the included spacer according to the diagram below. Failure to install the plastic spacer properly may result in the light being inadequately fastened. Plastic gunite type niches will not require the spacer. Refer to the manual for instructions when using a Swimquip niche. STEP 6: Install and wire Junction Box Transformer The junction box retrofit kit transformer must now be installed and wired. Cut excess cord and refer to the diagram for wiring instructions. If the new Universal ColorLogic/CrystaLogic light will be controlled by network communications using a Hayward Pro Logic controller, an LKBUN1000 coupler must also be installed. Refer to the LKBUN1000 instructions for installation and wiring information. After wiring the Universal ColorLogic/CrystaLogic light to the junction box transformer, install the new cover making sure that the included gasket is in place. STEP 9: Install Trim Ring Install the Trim Ring as shown. READ SAFETY INSTRUCTIONS AND COMPLETE SAFETY CHECKLIST INSIDE FRONT COVER OF MANUAL Hayward (R) is a registered trademark ColorLogic (TM) and CrystaLogic (TM) is a trademark of Hayward Pool Products, Inc. © 2012 Hayward Pool Products, Inc. All other trademarks not owned by Hayward are the property of their respective owners. Hayward is not in any way affiliated with or endorsed by those third parties. 092501 RevA