Hayward VR1000 Model: All Models - Owners Manual - Page 8

Page 8 of 16 SET TIMER EVENTS? Y/N STRATUM™ Model VR1000 P/N: ISVR1000 Rev: M The timer events are used to control the ON and OFF times of the Filter Pump, Booster Pump and Low Speed on a two speed Pump. Dip switch #4 Must be on to allow the timers to be set. A "YES" will allow the following timer settings. "YES" 7-day all the week long the pumps will run at the same times. Y= 7 DAY MODE "NO" Each days timers must be set N= EACH DAY MODE The 7-day time clock has two (2) on/off programs per day, while each day only has one program. All time clocks are selected either as "7-day" or "each day". If "each day" is selected, you will need to program "ON" times for every day and "OFF" times for every day, even if you want them all to be the same. All times are adjusted in 1 minute increments.). If you program the "ON" time equal to the "OFF" time ("12:01 AM to 11:59 PM") the output will always be "ON". For the Booster pump timer "ON" time equals "OFF" time the pump will always be "OFF" ON = 04:00 AM OFF=08:00 PM OK? 7 DAY MODE "YES" will use the timing events currently stored in the VR1000 "NO" will allow setting the timers Daily On Hour = 4 AM Daily On Min= 1 Blinking time indicates that the timer is ready to be set. "Down" will move On time earlier "UP" will move On time later. Menu/OK to go to next screen. Blinking time indicates that the timer is ready to be set. "Down" will move On time earlier "UP" will move On time later. Menu/OK to go to next screen. Daily Off Hour = 6 AM Blinking time indicates that the timer is ready to be set. "Down" will move On time earlier "UP" will move On time later. Menu/OK to go to next screen. Daily Off Min = 0 Blinking time indicates that the timer is ready to be set. "Down" will move On time earlier "UP" will move On time later. Menu/OK to go to next screen. Low Speed On= 08:00 AM OK? Low Speed On will only appear if dip switch 3 is "ON" This will allow setting the timing on the Low speed of a two speed pump. A "N" will allow setting the On and Off time. Follow the above instructions for the timer settings. BST On=04:00PM Off = 0400 PM OK? On=0700AM Mon Off= 0400PM OK? BST On is the timer for the Booster Pump. To set timer follow the above. Repeat the above for the second timer cycle. For "OVERNIGHT" operation, set the first timer cycle starting at midnight (12:01 AM) as the desired "ON" time and then the desired AM "OFF" time. The second timer cycle should be set from the desired PM "ON" time to midnight (11:59 PM) as the "OFF" time. EACH DAY MODE Note when each day mode is selected the timers must be set on a daily basis. Tue. = Mon OK? Y/N The week days will be stepped through to allow individual day setting. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Pomona, CA Clemmons, NC Nashville, TN Tel: 908.351.5400 www.haywardpool.com