HealthRider 290 R S Bike English Manual - Page 19

Distance (Dist.)-This display mode will show the distance that you have pedaled in miles or kilometers. Pulse-This display mode will show your heart rate when you use the handgrip heart rate monitor (see step 5). Resistance (Resist.)-This display mode will show the resistance level of the pedals for a few seconds each time the resistance level changes. Speed-This display mode will show your pedaling speed in miles per hour or kilometers per hour. Time-When the manual mode is selected, this display mode will show the elapsed time. When an onboard workout is selected, this display mode will show the time remaining in the workout. The matrix offers several display tabs. Press the Display button until the desired tab is shown. You can also press the increase and decrease buttons next to the Enter button. Speed-This tab will show a profile of the speed settings of the workout. A new segment will appear at the end of each minute. My Trail-This tab will show a track that represents 1/4 mile (400 m). As you exercise, the flashing rectangle will show your progress. The My Trail tab will also show the number of laps you complete. Calorie-This tab will show the approximate amount of calories you have burned. The height of each segment represents the amount of calories burned during that segment. As you exercise, the workout intensity level bar will indicate the approximate intensity level of your exercise. When a wireless iFit module is connected, the wireless symbol at the top of the display will show the strength of your wireless signal. Four arcs indicate full signal strength. To exit the manual mode or a workout, press the Home button. If necessary, press the Home button again. Change the volume level of the console by pressing the volume increase and decrease buttons. 5. Measure your heart rate if desired. If there are sheets of plastic on the metal contacts on the handgrip heart rate monitor, remove the plastic. To measure your heart rate, hold the handgrip heart rate monitor with your palms resting against the contacts. Avoid moving your hands or gripping the contacts tightly. When your pulse is detected, a heart symbol in the calorie display will flash each time your heart beats, one or two dashes will appear, and Contacts then your heart rate will be shown. For the most accurate heart rate read- ing, hold the contacts for at least 15 seconds. If the display does not show your heart rate, make sure that your hands are positioned as described. Be careful not to move your hands excessively or to squeeze the contacts tightly. For optimal performance, clean the contacts using a soft cloth; never use alcohol, abrasives, or chemicals to clean the contacts. 19