HealthRider 500 Sel Treadmill Canadian English Manual - Page 11
the Calories/Fat Calories/Heart Rate display will
View all HealthRider 500 Sel Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Time/Incline/Segment Time display-When the manual mode or the iFIT.com mode is selected, this display will show the elapsed time and the incline level of the treadmill. The display will change from one number to the other every few seconds, as shown by the indicators beside the display. When a personal trainer program or a heart rate program is selected, the display will show the time remaining in the program, the time remaining in the current segment of the program, and the incline level. Note: Each time the incline changes, the display will show the current incline setting for several seconds. Distance/Laps display-This display shows the distance that you have walked and the number of 1/4-mile laps you have completed. The display will change from one number to the other every few seconds, as shown by the indicator beside the display. Speed/Min-Mile display-This display shows the speed of the walking belt and your current pace (pace is measured in minutes per mile). The display will change from one number to the other every few seconds, as shown by the indicators beside the display. Note: Each time the speed changes, the display will show the current speed setting for several seconds. Note: When the Km/H indicator is not lit, the console will display speed and distance in miles; when the Km/H indicator is lit, the console will display speed and distance in kilometers. To change the unit of measurement, first hold down the Stop button while inserting the key into the console. An "E" (for English) or an "M" (for metric) will appear in the display. Press the Speed v button to change the system of measurement. When the desired system of measurement is selected, remove the key and then reinsert it. To reset the displays, press the Stop button, remove the key, and then reinsert the key. 6 Measure your heart rate, if desired. Note: Before using the handgrip pulse sensor, make sure that your hands are clean. To measure your heart rate, stand on the foot pads and hold the metal contacts on the handrail as shown-avoid moving your hands. When your pulse is detected, the Heart Rate indicator beside the Calories/Fat Calories/Heart Rate display will light, dashes will appear in the display and then your heart rate will be shown. For the most accurate heart rate reading, continue to hold the contacts for about 15 seconds. 7 When you are finished exercising, remove the key. Step onto the foot pads, press the Stop button, and adjust the incline of the treadmill to the lowest setting. The incline must be at the lowest setting when the treadmill is folded to the storage position or the treadmill will be damaged. Next, remove the key from the console and put it in a secure place. Note: If the displays and various indicators on the console remain lit after the key is removed, the console is in the "demo" mode. See page 20 and turn off the demo mode. When you are finished using the treadmill, move the on/off circuit breaker near the power cord to the off position and unplug the power cord.