HealthRider C860e English Manual - Page 8

8. Apply a small amount of grease to the axle on the left Crank Arm (36). Slide the Left Pedal Leg (14) onto the axle. Slide an M10 Bracket Washer (94) onto an M10 x 25mm Patch Screw (52), and tighten the Patch Screw into the axle. Attach the Right Pedal Leg (not shown) to the right side of the elliptical crosstrainer in the same way. 8 14 Grease 36 9. Position a Cushion (88) in one of the adjustment holes in the Left Pedal Leg (14). Set the Left Pedal Arm (15) on the Cushion, with the end of the Pedal Arm inside of the angled bracket on the Pedal Leg. Slide a Plastic Washer (19) between the Pedal Arm and the Pedal Leg. Insert the long part of the M10 Bolt Set (27) through the Pedal Leg, Plastic Washer, and Pedal Arm. Lift the Left Pedal Leg (14) and hold the left Handlebar Leg (79) inside of the bracket on the Left Pedal Arm (15). Slide the other Plastic Washer (19) between the Pedal Arm and the Pedal Leg. Insert the long part of the M10 Bolt Set (27) through the Handlebar Leg, Pedal Arm, Plastic Washer, and Pedal Leg. Tighten the short part of the Bolt Set into the long part. Attach the Right Pedal Arm (not shown) to the Right Pedal Leg (not shown) and the right Handlebar Leg (79) in the same way. Tighten the M6 x 25mm Screw (63) into the Upright (2). Turn the Upright Knob (91) clockwise until it is tight. Refer to step 6. Tighten the M8 x 45mm Button Bolts (83) in the Handlebar Legs (79). 94 52 9 63 79 79 15 19 19 Grease 27 27 14 2 91 88 10. Make sure that all parts of the elliptical crosstrainer are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical crosstrainer. 8