HealthRider Crosstrainer C860e Elliptical English Manual - Page 20
Maintenance And Troubleshooting
View all HealthRider Crosstrainer C860e Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
MAINTENANCE AND TROUBLESHOOTING Inspect and tighten all parts of the elliptical crosstrainer regularly. Replace any worn parts immediately. To clean the elliptical crosstrainer, use a damp cloth and a small amount of mild detergent. Important: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight. BATTERY REPLACEMENT If the console display becomes dim, the batteries should be replaced; most console problems are the result of low batteries. Refer to assembly step 5 on page 7 for replacement instructions. The console requires four "D" batteries. HOW TO ADJUST THE REED SWITCH If the console does not display correct feedback, the reed switch should be adjusted. To do this, you must first remove the Pedal Legs (13, 14), the right Pedal Disc (8), and the Side Shields (6, 7). Refer to steps 8 and 9 on page 8 and remove the Pedal Legs. 14 67 78 6 90 65 90 67 13 67 66 66 65 Refer to the drawing below and locate the Reed Switch (77). Loosen, but do not remove, the indicated M4 x 16mm Screw (66). Slide the Reed Switch slightly toward or away from the Magnet (43) on the flywheel. Retighten the Screw. Turn the Left Crank Arm (36) for a moment. Repeat until the console displays correct feedback. When the Reed Switch is correctly adjusted, reattach the Side Shields (6, 7), the right Pedal Disc (8), and the Pedal Legs (13, 14). 43 77 36 66 HANDGRIP PULSE SENSOR TROUBLESHOOTING • Avoid moving your hands while using the handgrip pulse sensor. Excessive movement may interfere with heart rate readings. • Do not hold the metal contacts too tightly; doing so may interfere with heart rate readings. • For the most accurate heart rate reading, hold the metal contacts for about 15 seconds. • For optimal performance of the handgrip pulse sensor, keep the metal contacts clean. The contacts can be cleaned with a soft cloth-never use alcohol, abrasives, or chemicals. Next, remove the four Screws (65) from the right Pedal Disc (8), and remove the Pedal Disc. Remove all of the Screws (66, 67) from the Right Side Shield (7) and the two Bolts (90) that were under the Pedal Disc, and remove the Right Side Shield. Remove all of the Screws (66) from the Left Side Shield (6) and remove the Left Side Shield. 20