HealthRider H30t Treadmill Enc Manual - Page 18

HOW TO USE A PRESET WORKOUT 1. Insert the key into the console.  See HOW TO TURN ON THE POWER on page 16. 2. Select a preset workout. At the end of each segment, a series of tones will sound and the next segment of the profile will begin to flash. If a different speed and/or incline setting is programmed for the next segment, the speed and/ or incline setting will flash in the display to alert you. The treadmill will then automatically adjust to the speed and incline settings for the next segment. To select a preset workout, press the Wt. Loss Workouts button or the Performance Workouts button repeatedly until the desired workout appears in the display. When you select a workout, the maximum speed and incline settings of the workout will flash in the displays for a few seconds; then the display will show how long the workout will last. A profile of the speed settings of the workout will scroll across the matrix. 3. Start the walking belt. Press the Start button or the Speed increase button to start the workout. A moment after you press the button, the treadmill will automatically adjust to the first speed and incline settings for the workout. Hold the handrails and begin walking. The workout will continue in this way until the last segment of the profile flashes in the display and the last segment ends. The walking belt will then slow to a stop. If the speed or incline setting for the current segment is too high or too low, you can manually override the setting by pressing the Speed and Incline buttons; however, when the current segment of the workout ends, the treadmill will automatically adjust to the speed and incline settings for the next segment. To stop the workout at any time, press the Stop button. To restart the workout, press the Start button or the Speed increase button. The walking belt will begin to move at 1 mph. When the next segment of the workout begins, the treadmill will automatically adjust to the speed and incline settings for that segment. 4. Follow your progress with the displays.  Each workout is divided into 30 one-minute segments. One speed setting and one incline setting are programmed for each segment. Note: The same speed and incline settings may be programmed for consecutive segments. See step 5 on page 17. 5. Measure your heart rate if desired. See step 6 on page 17. During the workout, the profile will show your Current Segment progress. The flashing segment of the profile represents the current segment of the workout. The height of the flash- ing segment indicates the speed setting for the current segment. 6. When you are finished exercising, remove the key from the console. See step 7 on page 17. 18