HealthRider H92 E Elliptical English Manual - Page 7

3. Orient the Upright (5) and the Top Cover (27) as shown, and slide the Top Cover upward onto the Upright. Have a second person hold the Upright (5) and the Top Cover (27) near the Main Frame (1). Locate the wire tie in the Upright (5). Tie the lower end of the wire tie to the Wire Harness (60). Next, pull the upper end of the wire tie until the Wire Harness is routed through the Upright. Tip: To prevent the Wire Harness (60) from falling into the Upright (5), secure the Wire Harness with the wire tie. Tip: Avoid pinching the Wire Harness (60). Slide the Upright (5) onto the Main Frame (1). Attach the Upright (5) with four M8 x 16mm Screws (102) and four M8 Split Washers (103); do not tighten the Screws yet. Slide the Top Cover (27) downward; do not press the Top Cover onto the Frame Covers (21, 22) yet. 3 Wire Tie 102 5 103 102 27 22 Avoid pinching the Wire Harness (60) 102 103 Wire Tie 60 1 21 4. Apply a generous amount of the included grease to the Upright Axle (48) and to two Wave Washers (118). Tip: Avoid damaging the Wire Harness (60). Insert the Upright Axle (48) through the Upright (5) and center it. Slide a Wave Washer (118) onto each side of the Upright Axle. Next, identify the Right and Left Upper Body Legs (6, 7), which are marked with “"Right”" and “"Left”" stickers, and orient them as shown. Slide the Right and Left Upper Body Legs (6, 7) onto the right and left sides of the Upright Axle (48). Tighten an M8 x 16mm Screw (102) and an M8 Washer (95) into each end of the Upright Axle (48). 4 60 102 95 118 7 5 7 Avoid damaging the Wire Harness (60) Grease 48 118 95 102 6