HealthRider Q 400 Treadmill English Manual - Page 9

8. With the help of a second person, hold the Console Base (47) near the Left Handrail (71). Attach the end of the ground wire to the indicated small hole in the Left Handrail with the Silver Ground Screw (75). 8 Ground Wire 47 Small Hole 75 71 9. Touch the Right Handrail (72) to discharge any static. See the inset drawing. Slide the sleeve off the connector on the Upright Wire (42). Next, press the end of the Upright Wire into the socket in the bottom of the Console Base (47). The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF THE CONNECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Then, slide the sleeve back over the connector. 9 72 42 47 Sleeve Connector 42 10. Set the Console Base (47) on the Handrails (71, 72). Attach the Console Base with four 3/4" Screws (2). Start all four Screws before tightening them; do not overtighten the Screws. See the lower drawing. Make sure that the Upright Wire (42) is routed below the two indicated round posts (A). Next, press the Upright Wire into the slot between the square post (B) and the Console Base (47). 10 72 2 47 71 2 A B 42 47 9