HealthRider Rc150 English Manual - Page 12
Maintenance And Troubleshooting
View all HealthRider Rc150 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
6 Turn off the power To turn off the power, simply wait for about six minutes. If the pedals are not moved and the console buttons are not pressed for six minutes, the power will turn off automatically. HOW TO SELECT KILOMETERS OR MILES The console can display distance and speed in either kilometers or miles. If a ÒKPHÓ appears in the display, distance and speed will be shown in kilometers; if a ÒKPHÓ does not appear, distance and speed will be shown in miles. To change the unit of measurement, see step 5 on page 7 and remove the Handlebar. Next, remove the four indicated screws from the console. Lift the console a few inches and turn it over; be careful not to pull on the wires. Switch Screws Locate the small switch on the back of the console. Slide the switch up or down to change the unit of measurement. Reattach the console with the four screws; be careful not to pinch any of the wires. MAINTENANCE AND TROUBLESHOOTING Inspect and tighten all parts of the recumbent cycle regularly. The recumbent cycle can be cleaned with a soft, damp cloth. To prevent damage to the console, keep liquids away from the console and keep the console out of direct sunlight. BATTERY REPLACEMENT If the console does not function properly, the batteries should be replaced. To replace the batteries, the handlebar must be removed. See assembly step 4 on page 7 to remove the handlebar. Next, refer to assembly step 5 to install batteries. PULSE SENSOR TROUBLE-SHOOTING ¥ Avoid moving your hands while using the pulse sensor. Excessive movement may interfere with heart rate readings. ¥ If your heart rate is not shown when the pulse sensor is used, press the resistance Ð button to reset the pulse sensor. ¥ Do not hold the metal contacts too tightly; doing so may interfere with heart rate readings. ¥ For the most accurate heart rate reading, hold the metal contacts for about 15 seconds. ¥ For optimal performance of the pulse sensor, keep the metal contacts clean. The contacts can be cleaned with a soft clothÑnever use alcohol, abrasives, or chemicals. 12