HP 1120NR HP Mini 1000 Netbook - Maintenance and Service Guide - Page 52
Remove the Phillips PM2.0×3.0 screw, Remove the WLAN module
UPC - 884420800767
View all HP 1120NR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Remove the WLAN module: 1. Disconnect the wireless antenna cables (1) from the terminals on the WLAN module. 2. Remove the Phillips PM2.0×3.0 screw (2) that secures the WLAN module to the system board. (The edge of the module opposite the slot rises away from the device.) 3. Remove the WLAN module (3) by pulling the module away from the slot at an angle. NOTE: WLAN modules are designed with a notch (4) to prevent incorrect insertion. Reverse this procedure to install the WLAN module. 44 Chapter 4 Removal and replacement procedures
Remove the WLAN module:
1.
Disconnect the wireless antenna cables
(1)
from the terminals on the WLAN module.
2.
Remove the Phillips PM2.0×3.0 screw
(2)
that secures the WLAN module to the system board.
(The edge of the module opposite the slot rises away from the device.)
3.
Remove the WLAN module
(3)
by pulling the module away from the slot at an angle.
NOTE:
WLAN modules are designed with a notch
(4)
to prevent incorrect insertion.
Reverse this procedure to install the WLAN module.
44
Chapter 4
Removal and replacement procedures