HP 15-g020ca HP 15 Notebook PC Compaq 15 Notebook PC Maintenance and Service G - Page 62
Power connector cable, Position the computer upright
View all HP 15-g020ca manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
● WLAN module (see WLAN module on page 48) ● Hard drive (see Hard drive on page 46) NOTE: When replacing the system board, be sure that the following components are removed from the defective system board and installed on the replacement system board: ● Memory module (see Memory module on page 62) ● Heat sink assembly (see Heat sink assembly on page 58) To remove the system board: 1. Position the computer upright, and then disconnect the following cables from the system board: (1): Power connector cable (2): Speaker cable (3): Fan cable (4): Display cable 2. Remove the two Phillips PM2.5×5.0 screws (5) that secure the system board to the computer. 54 Chapter 4 Removal and replacement procedures
●
WLAN module (see
WLAN module
on page
48
)
●
Hard drive (see
Hard drive
on page
46
)
NOTE:
When replacing the system board, be sure that the following components are removed from the
defective system board and installed on the replacement system board:
●
Memory module (see
Memory module
on page
62
)
●
Heat sink assembly (see
Heat sink assembly
on page
58
)
To remove the system board:
1.
Position the computer upright, and then disconnect the following cables from the system board:
(1)
: Power connector cable
(2)
: Speaker cable
(3)
: Fan cable
(4)
: Display cable
2.
Remove the two Phillips PM2.5×5.0 screws
(5)
that secure the system board to the computer.
54
Chapter 4
Removal and replacement procedures