HP 1800 24G Configuration Guide - Page 19
Subnet Mask, Gateway IP Address, Management VLAN, Click System, IP Address. Enter the IP address - procurve default ip
UPC - 883585137732
View all HP 1800 24G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Note Using the ProCurve Web Browser Interface Web Configuration • Subnet Mask - This mask identifies the host address bits used for routing to specific subnets. (Default: 255.255.255.0) • Gateway IP Address - IP address of the gateway router between this device and management stations that exist on other network segments. (Default: 0.0.0.0) • Management VLAN - ID of the configured VLAN (1-4093, no leading zeroes). By default, all ports on the switch are members of VLAN 1. However, the management station can be attached to a port belonging to any VLAN, as long as that VLAN has been assigned an IP address. Be sure to keep a record of the switch's IP address. If you cannot remember the switch's IP address, you can restore the original settings by following the procedure described in the "Troubleshooting" section. If you change the switch IP address, you must close the Web interface and start a new session using the new IP address. Web - Click System, IP Address. Enter the IP address, subnet mask, gateway, and select the Management VLAN, then click APPLY Using the ProCurve Web Browser Interface 2-9