HP 22.1kVA PDU MANAGEMENT MODULE INSTALLATION INSTRUCTIONS - Page 1

HP PDU Management Module Installation Instructions © Copyright 2005 Hewlett-Packard Development Company, L.P. The information contained herein is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for technical or editorial errors or omissions contained herein. Microsoft and Windows are U.S. registered trademarks of Microsoft Corporation. November 2005 (First Edition) Part Number 404318-021 Overview The HP PDU Management Module enables you to monitor and manage power environments of up to two single input PDUs per management module. For more information about any of the topics covered in this document, refer to the HP PDU Management Module User Guide located on the HP website (http://www.hp.com/go/rackandpower). Kit contents • This document • Warranty information • Management module and mounting hardware • Serial cable To download the latest version of management module firmware, visit the HP website (http://www.hp.com/go/rackandpower). Required tools • Phillips screwdriver • Flat-head screwdriver Installing the management module Install the management module on a single or dual PDU. For a detailed list of supported PDUs, refer to the HP website (http://www.hp.com/go/rackandpower). NOTE: It is not necessary to power down the PDU before installing the management module. 1. Connect the serial connector on the rear panel of the management module to the serial connector marked Port 2 on the PDU. 2. Secure the serial connection using the screws provided.