HP 2410 HP PSC 2400 Photosmart series All-in-One - (English) Setup Poster - Page 2
psc 2400 photosmart series all-in-one - psc photosmart all in one
View all HP 2410 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
1 Macintosh Users START HERE This side of the poster is for Macintosh users. Make sure you are using the correct side of the poster and CD for your operating system. 4 Connect phone cord a You must connect the supplied phone cord to the phone jack on the left (1-LINE). b To connect an answering machine or use your own phone cord, see the Fax Setup chapter in the Reference Guide. 1-LINE 8 Insert print cartridges 2 Attach front panel cover a Remove any packaging material. b Place the front panel cover over the buttons. Firmly press on all sides to snap the cover in place. Make sure all the buttons are visible. c Lift the display. 3 Load paper a b Use blank white paper to prepare for print alignment. c d 5 Connect power cords 6 Connect USB cable a b Do not connect the USB cable into a keyboard. c 7 Turn HP PSC on a Turn power on. b Wait for the print cartridge message to appear, and then continue to the next step. 9 Align print cartridges a Make sure the power is on. Lift the print carriage door up until it catches. Lift the blue and gray latches. b Remove the bright pink tape from both print cartridges. Do not touch the gold-colored contacts or retape the cartridges. c Hold the black print cartridge with the HP logo on top. Slide the cartridge underneath the metal bar into the right (gray latch) side of the print carriage. d Press down on the gray latch until it locks into place. Insert the color cartridge on the left side, and lock into place. Tri-Color Black e Make sure both latches are locked into position. Close the door. Press OK on the front panel to begin alignment. After a page prints, alignment is complete. Discard or recycle this page. Macintosh setup poster hp psc 2400 photosmart series all-in-one 10 Install software a Turn on your Macintosh and wait for the desktop to appear. Insert the HP PSC Macintosh CD. b Double-click the HP AllIn-One Installer icon in your folder. c Follow the onscreen instruction. Make sure you complete the Setup Assistant. 11 Congratulations! You are ready to begin using your HP device. See the Reference Guide to get started. Have fun!