HP 3300mfp HP PCL/PJL reference - PCL 5 Comparison Guide - Page 118
AppleTalk Configuration Command, discussed RENAME, TYPE, and JOB, the HP Color LaserJet printer
UPC - 088698450581
View all HP 3300mfp manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 118 highlights
Table 2-10. PCL Feature Additions for HP Color LaserJet Printer (continued) Feature Status PC (Pen Color-HP-GL/2) New Push/Pop Palette Raster Scaling New New/Modified Render Algorithm New Select Palette by ID New Set Viewing Illuminant New Simple Color Transfer Raster Graphics (by plane) New New Comments Changes the pen color in a palette created by the IN or CID command (?*v#W). Pushes or pops the palette from the palette stack. Several commands are added for raster scaling: Destination Raster Width (?*t#H), Destination Raster Height (?*t#V); also, two parameters are added to the Start Raster Graphics command to initiate scaling (?*r2A and ?*r3A). (See the PCL 5 Color Technical Reference Manual for more information.) Selects the algorithm to be used for rendering page marking entities on a given page. Activates a palette with the specified ID number. Specifies the relative white point used in the determination of a viewing illuminant condition. Specifies an unmodifiable fixed-size palette. Provides a means to send raster data by color plane. This command sends a plane of raster data to the printer and advances to the next plane. AppleTalk Configuration Command As discussed in the HP LaserJet 4 section of this chapter, the AppleTalk Configuration command allows a user to send PCL jobs to the printer over AppleTalk. In addition to the key values previously discussed (RENAME, TYPE, and JOB), the HP Color LaserJet printer also supports the ZONE key value as follows. ZONE ZONE changes the zone field of the printer's AppleTalk Network Identifier (Name Binding Protocol type field). ?&b#WZONEzonename Valid characters for the zone name include 0-255 except for characters $00, "@" ($40), ":" ($3A), "*" ($2A), "=" ($3D), $C5, and ($FF). The zone name must contain at least one character, and only the first 31 characters are used. If the zone is invalid, then the printer's zone is not changed. Zone changes only occur after the present job has completed. 2-70 Printer-Specific Differences ENWW