HP 350 Business Notebook and Desktop PC F10 setup overview 2012 and 2013 Busin - Page 7

, EMBEDDED SECURITY Feature Function Default setting, Reboot if applicable required BIOS Integrity Checking (Note: HP Sure Start is only supported on 2013 EliteBook and ZBook notebooks) N/A  Verify Boot Block on every boot Verify the integrity of the system's boot block on boot. Disabled Yes  BIOS Data Recovery Policy Recover System Data (For manual recovery during boot up press (Up Automatic Yes Arrow + Down Arrow + ESC) to restore System Data  Restore Network Configuration Restore the network address and other network parameters to factory Yes to factory defaults default TPM Embedded Security Manages TPM Module settings N/A  TPM Device Exposes the integrated TPM module Available Yes  Embedded Security Device State Enables the integrated TPM module Disabled Yes  TPM Reset to Factory Default Sets TPM Embedded Security settings to factory default No Yes  OS Management of TPM Allows operating system to manage TPM module Enabled Yes  Reset of TPM from OS Allows reset of TPM module from within the operating system Disabled Yes System Management Command Allows authorized personnel to reset security settings in case of a Enabled Yes service event NOTE: In the event BIOS password is lost and this option is disabled authorized personnel will not be able to remove lost password. UTILITIES Anti-Theft Tools N/A  Intel Anti-Theft Server-based security N/A - Active Activates this option - Suspend Allows the feature to be disabled temporarily  Absolute Software Computrace Enabled Yes Disabled Yes N/A - Current State Read-only setting that reports the current status [Inactive/Active/Permanent Disabled] Inactive N/A Hard Drive Tools N/A  Save/restore Master Boot Saves a baseline MBR that can be restored if a change is detected Disabled Yes Record (MBR) of the system NOTE: Not applicable for UEFI boot modes hard drive  DriveLock Allows configuration of DriveLock Master and User passwords Disabled N/A  Automatic DriveLock Requires the BIOS to authenticate the user before the drive is unlocked. Disabled N/A The user can be a BIOS user (managed by F10 Setup) or a ProtectTools user (managed by the OS). Following authentication, the BIOS automatically supplies the DriveLock password. A BIOS administrator password is required for this feature and is set as the DriveLock master password.  Disk Sanitizer Erases all data on selected hard drive; typically used prior to N/A repurposing or donation (Not supported under RAID mode or on SSDs)  Secure Erase Uses a built-in command drive to erase data on an SSD N/A System IDs  Asset Tracking Number  Ownership Tag  Ownership Tag 2 N/A Allows custom configuration of an asset tag (up to 18 characters) Serial Number No Allows custom configuration of an ownership tag (up to 40 characters) Blank No Allows custom configuration of an ownership tag (up to 40 characters) Blank No 7