HP 4050tn HP PCL/PJL reference (PCL 5 Color) - Technical Reference Manual - Page 155
End Raster Graphics Command, Refer to the PCL Feature Support Matrix in of - laserjet support
UPC - 088698769577
View all HP 4050tn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 155 highlights
End Raster Graphics Command The End Raster Graphics command signifies the end of a raster graphic data transfer. ? * r C Receipt of this command causes 5 operations: • Resets the raster compression seed row to zeros. • Moves the cursor to the raster row immediately following the end of the raster area (if a source raster height was specified). • Allows raster commands which were previously locked out to be processed. • Sets compression mode to 0 (no compression). • Defaults the left graphics margin to X-position 0. Note This command is a modified version of the ?*rB End Raster Graphics command. The newer version (?*rC) performs two additional operations: it resets the compression mode to 0 and defaults the left graphics margin to 0. This command (?*rC) is not supported by the HP LaserJet III or the HP LaserJet IIID printers. Use the ?*rB End Raster Graphics command to terminate raster graphic data transfers for these printers. Refer to the "PCL Feature Support Matrix" in Chapter 1 of the PCL 5 Comparison Guide for specific printers which support these commands. EN Raster Graphics 6-35