HP 507610-B21 Hot-Pluggable SAS and SATA Hard Drive Installation Instructions - Page 1

HP Hot-Pluggable SAS and SATA Hard Drive Installation Instructions for HP ProLiant Servers Read instructions completely before beginning installation procedure. Additional information For the latest information and instructions regarding HP branded or Compaq branded hard drives, such as Hard Drive Compatibility tables, Important cards, and updated installation instructions, refer to the Technical Information area on the HP website at http://www.hp.com/products/harddiskdrives. Availability of Japanese documentation To view or download Japanese versions of HP hard drive documentation, go to http://www.hp.com/jp/manual/. To order a hard copy of the HP hard drive documentation in Japanese, please contact the HP Japan Customer Care Center and provide them with a hard drive kit number and a serial number. HP Japan Customer Care Center: 0120-014121 Installation overview 1. Review guidelines-When replacing a failed drive, refer to the documentation included with the server or disk enclosure system to identify and remove a failed drive. 2. Remove the failed drive-Follow the steps shown on this card. 3. Install the hot-pluggable hard drive-Follow the steps shown on this card. 4. Follow all hard drive handling precautions-Hard drives are sensitive electromechanical devices that can be permanently damaged through improper handling. The packaging provided with a hard drive is designed to protect it from accidental drops. HP recommends that hard drives remain in their original packaging until installation. Drives should be handled with care and never dropped, even from short distances. CAUTION: Electrostatic discharge can damage electronic components. Be sure you are properly grounded before beginning this procedure. Refer to the documentation that came with your computer or contact your HP authorized reseller for procedures to discharge static electricity. Installing the hard drive Follow these steps to install a hot-pluggable hard drive in a system. If you are removing the blank drive bezel, begin with step 1. If you are removing a failed drive, begin with step 2. 1. Remove the blank drive bezel from the disk enclosure before installing a new hard drive. a. Press the ejector buttons simultaneously. b. Pull the blank drive bezel from the disk enclosure. © Copyright 2004, 2005 Hewlett-Packard Development Company, L.P. The information contained herein is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for technical or editorial errors or omissions contained herein. Second Edition (February 2005) Part Number 370802-002