HP 510B Maintenance & Service Guide: HP 500B and 505B, Compaq 500B and 505 - Page 26
Caution
View all HP 510B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
10. If present, remove any cables connected to the add-in card. Figure 2-19 Removing cables from the card 11. Store the removed card in anti-static packaging. 12. If you are not installing a new expansion card, install an expansion slot cover to close the open slot. CAUTION: After removing an expansion card, you must replace it with a new card or expansion slot cover for proper cooling of internal components during operation. 13. To install a new expansion card, hold the card just above the expansion socket on the system board then move the card toward the rear of the chassis so that the bottom of the bracket on the card slides into the small slot on the chassis. Press the card straight down into the expansion socket on the system board. Figure 2-20 Installing an expansion card NOTE: When installing an expansion card, press firmly on the card so that the whole connector seats properly in the expansion card slot. 18 Chapter 2 Removal and Replacement Procedures Microtower (MT) Chassis