HP 5600 TFT5600 Rackmount Keyboard and Monitor (RKM) Installation Instructions - Page 3
mounting rail opening. - parts
UPC - 720591607586
View all HP 5600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
5. Install the tray assembly. a. Fully extend the sliding rails until locked (1). b. Place the tray assembly on the rails, aligning the screw holes on the tray with the tabs on the rails (2). c. Secure with two 6-32 screws on each side (3). 3 3 2 3 1 3 1 6. Attach the cable management arm to the rear of the tray with two 6-32 screws. 8. Place the tray back into the rack. a. Slide the locking bar (1) to unlock. IMPORTANT: If the TFT5600 RKM is not properly aligned with other rack-mounted devices when installed, cosmetic damage to the top of the unit can occur due to interference. Leave protective sheet on the unit while adjusting. b. Carefully push the tray (2) into the rack. IMPORTANT: If the TFT5600 RKM interferes with the other rack-mounted devices, above or below, loosen the M-6 screws on the mounting rails to make appropriate adjustments. Installation is complete. 7. Carefully route the keyboard power and video cables into the cable management arm. Then route the cables through the mounting rail opening. HP CONFIDENTIAL Writer: Amy L. Laffitte Codename:RUGER Part Number: 230201-022 Last Saved On: 9/3/02 3:33 PM