HP 600 HP StorageWorks 600 Modular Disk System Maintenance and Service Guide - Page 49
Install the hard drive drawer., Install the cable management arm.
View all HP 600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
CAUTION: To avoid damage to the equipment, be sure that the cables are properly connected. The red cable is 12V. The black cable is GND. 2. Install the backplane board: a. Be sure the board is lined up on the standoffs. b. Install the screws. 3. Connect the LED panel cable. 4. Install the cover. 5. Install the cable management arm. 6. Install the hard drive drawer. 7. Install the hard drives. 8. Close the hard drive drawer. 9. Install all rear panel components. 10. Connect the cables. Removal and replacement procedures 49
Removal and replacement procedures
49
CAUTION:
To avoid damage to the equipment, be sure that the cables are properly connected.
The red cable is 12V. The black cable is GND.
2.
Install the backplane board:
a.
Be sure the board is lined up on the standoffs.
b.
Install the screws.
3.
Connect the LED panel cable.
4.
Install the cover.
5.
Install the cable management arm.
6.
Install the hard drive drawer.
7.
Install the hard drives.
8.
Close the hard drive drawer.
9.
Install all rear panel components.
10.
Connect the cables.