HP 6120G/XG ProCurve Series 6120 Blade Switches Management and Configuration G - Page 359

Configuring for Network Management Applications Using SNMP Tools To Manage the Switch SNMPv3 User Commands Syntax: [no] snmpv3 user Adds or deletes a user entry for SNMPv3. Authorization and privacy are optional, but to use privacy, you must use authorization. When you delete a user, only the is required. [auth ] With authorization, you can set either MD5 or SHA authentication. The authentication password must be 6-32 characters in length and is mandatory when you configure authentication. Default: None [priv ] With privacy, the switch supports DES (56-bit) and AES (128-bit) encryption. The privacy password must be 6-32 characters in length and is mandatory when you configure privacy. Default: DES Note: Only AES 128-bit and DES 56-bit encryption are supported as privacy protocols. Other non-standard encryption algorithms, such as AES-172, AES-256, and 3-DES are not supported. Listing Users. To display the management stations configured to access the switch with SNMPv3 and view the authentication and privacy protocols that each station uses, enter the show snmpv3 user command. Syntax: show snmpv3 user This example displays information about the management stations configured on VLAN 1 to access the switch. ProCurve# configure terminal ProCurve(config)# vlan 1 ProCurve(vlan-1)# show snmpv3 user Status and Counters - SNMPv3 Global Configuration Information User Name ----------initial NetworkAdmin Auth. Protocol MD5 MD5 Privacy Protocol CFB AES-128 CBC-DES 13-11