HP 6125G HP 6125G & 6125G/XG Blade Switches IP Multicast Command Refer - Page 18

With no parameters specified or with only vlan, count, or both of them specified, this command displays all MAC address table entries, including static multicast MAC address entries and unicast MAC address entries. Related commands: mac-address multicast; display mac-address (Layer 2-LAN Switching Command Reference). Examples # Display the static multicast MAC address entries for VLAN 2. display mac-address multicast vlan 2 MAC ADDR VLAN ID STATE PORT INDEX 0100-0001-0001 2 Multicast GigabitEthernet1/0/1 GigabitEthernet1/0/2 GigabitEthernet1/0/3 GigabitEthernet1/0/4 AGING TIME(s) NOAGED --- 1 mac address(es) found --- Table 4 Command output Field MAC ADDR VLAN ID STATE PORT INDEX AGING TIME(s) 1 mac address(es) found Description MAC address. ID of the VLAN to which the network device identified by the MAC address belongs. Status of the MAC address; multicast indicates a static multicast MAC address entry. Outgoing ports of the multicast MAC address entry. State of the aging timer. The aging timer for static multicast MAC addresses has only one state NOAGED, which indicates that this entry never expires. One static multicast MAC address entry is found. dot1p-priority (IGMP-snooping view) Syntax dot1p-priority priority-number View undo dot1p-priority IGMP-snooping view Default level 2: System level Parameters priority-number: Specifies an 802.1p precedence for IGMP messages, in the range of 0 to 7. A higher number indicates a higher precedence. Description Use dot1p-priority to set the 802.1p precedence for IGMP messages globally. 6