HP 6930p installing UEFi-based Microsoft Windows Vista SP1 (x64) on HP EliteBo - Page 3

Figure 3: Screenshot of the Device Configuration page While on the Device Configuration page, make sure the UEFI Boot Mode is enabled. Also, if HP QuickLook 2 application use is desired, make sure HP QuickLook 2 is enabled as well. Now exit the Setup, making sure to save these changes - the system will reboot. Step 2: After the system reboots, press and then select . On the F9 menu, select the "Boot From EFI File" option (this option only shows up when the PC is in the UEFI Boot Mode). See Figure 4. Note: Selecting the "Boot From EFI File" option enables launching the Windows Setup process from the installation media using the UEFI boot method on the Windows installation DVD. The UEFI boot of Windows Setup is required for Windows to configure the installed operating system for UEFI boot. If the UEFI boot method on the installation DVD is not used, Windows Setup will launch using BIOS firmware by default, and the installed operating system will use BIOS boot. 3