HP 8/40 Converged Enhanced Ethernet Administrator's Guide v6.4.0 (53-1001761-0 - Page 92
Configuring the LACP system priority, Configuring the LACP timeout period on a CEE interface,
View all HP 8/40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 92 highlights
DRAFT: BROCADE CONFIDENTIAL 6 LACP configuration and management 3. Enter the no shutdown command to enable the CEE interface. 4. Enter the channel-group command to configure the LACP for the CEE interface. Example switch(conf-if)#channel-group 4 mode active type brocade Configuring the LACP system priority You configure an LACP system priority on each switch running LACP. LACP uses the system priority with the switch MAC address to form the system ID and also during negotiation with other switches. The system priority value must be a number in the range of 1 through 65535. The higher the number, the lower the priority. The default priority is 32768. To configure the global LACP system priority, perform the following steps from Privileged EXEC mode. 1. Enter the configure terminal command to access global configuration mode. 2. Specify the LACP system priority. Example switch(config)#lacp system-priority 25000 Configuring the LACP timeout period on a CEE interface The LACP timeout period indicates how long LACP waits before timing out the neighboring device. The short timeout period is 3 seconds and the long timeout period is 90 seconds. The default is long. To configure the LACP timeout period on a CEE interface, perform the following steps from Privileged EXEC mode. 1. Enter the configure terminal command to access global configuration mode. 2. Enter the interface command to specify the CEE interface type and slot/port number. Example of selecting the Ten Gigabit Ethernet port number 0/1. switch(config)#interface tengigabitethernet 0/1 3. Enter the no shutdown command to enable the CEE interface. 4. Specify the LACP timeout period for the CEE interface. Example switch(conf-if-te-0/1)#lacp timeout short Clearing LACP counter statistics on a LAG To clear LACP counter statistics, perform the following task from Privileged EXEC mode. 1. Enter the clear command to clear the LACP counter statistics for the specified LAG group number. Example of clearing counter statistics on LAG group 42 switch#clear lacp 42 counters 70 Converged Enhanced Ethernet Administrator's Guide 53-1001761-01