HP 9040mfp HP LaserJet MFP - Analog Fax Accessory Guide - Page 109
General fax problems - m9040 mfp manual
UPC - 829160403649
View all HP 9040mfp manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 109 highlights
General fax problems Use the table in this section to solve fax problems. Problem Cause Solution Fax failed to send. JBIG is enabled and receiving fax does Set JBIG off. not have JBIG capability. An "Out of Memory" status message appears on the status message bar. The MFP storage disk is full. Delete some files from the disk, see the MFP user guide for information about managing the disk. Print quality of a photo is poor or prints Wrong Page Content mode setting. as a gray box. Try setting the Page Content mode to Graphics or Text and Graphics, see Send a fax - enter number(s) manually on page 70, or refer to Page Content mode in the MFP user guide. Pressed the Cancel button on the MFP keyboard to cancel a fax transmission and the fax was still sent. The Cancel button only is functional on some mfps (9040, 9050, 4345, 4730, 9500) if the fax job screen is being displayed. Also, there can be a delay of up to 30 seconds before the cancellation takes place. On newer MFPs (M5035, M3025 MFP, M3027 MFP, M4345 MFP, M5025 MFP, M5035 MFP, M9040 MFP, M9050 MFP and HP CM4730 MFP and CM6040 MFP Series) cancellation takes place after making a selection in the cancellation menu (displayed after pressing red Stop button) and acknowledging with OK. Cancel faxes using the fax menu, see Canceling a fax on page 80. No Phone Book button appears. The Phone Book feature has not been enabled. Use the HP MFP Digital Sending Software Configuration utility to enable the phone book feature. Not able to locate the Fax settings in HP Web Jetadmin. Fax settings in HP Web Jetadmin are located under the device's status page drop-down menu. Select Digital Sending and Fax from the drop-down menu. For more information, see HP Web Jetadmin on page 42. The header is being appended to the top The fax will append the overlay header to This is normal operation. of the page when I have overlay enabled. the top of a page when overlay is set, when the fax has been forwarded. Have a mix of names and numbers in the recipients box. This is normal for both names and numbers to appear, depending on where they are from, the phone book lists names, and all other databases list numbers. Normal, no action required. My one page fax prints as two pages. The fax header is being appended to the If you want your one page fax to print on top of the fax, pushing text to a second one page, set the overlay header to page. overlay mode. Document stops feeding in the middle of There might be a jam in the ADF. faxing. If there is a jam, see the MFP user guide for instructions on clearing jams. The volume for sounds coming from the The volume setting needs to be adjusted. See Set the ringer volume on page 63 for fax accessory is too high or too low. information about changing the sound volume settings. ENWW General fax problems 101