HP 9050 HP LaserJet MFP and Color MFP Products - Configuring Security for Mult - Page 20
Refresh, View Log, Apply, Go Back, Multiple Device Configuration Tool, Security - laserjet default password
UPC - 829160315386
View all HP 9050 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Figure 10: The View Log page showing that SNMPv3 is executing. 7. Wait a few seconds (sometimes this can take a few minutes), and click Refresh to see the progress. The View Log page will reappear with the status. Once the configuration is complete, the View Log page will show success (Figure 11). Figure 11: The View Log page showing successful configuration of SNMPv3. Now, whenever you click Apply to configure settings, the MFP will check for the SNMPv3 credentials. Note Web Jetadmin stores the credentials for each MFP for convenience, but it may prompt for them on occasion. Web Jetadmin stores these credentials encrypted. Click Go Back to view Multiple Device Configuration Tool, and continue with this checklist. The next step is to configure the Bootloader Password for each of the MFPs. Keep Web Jetadmin open to the Security configuration page to continue. Configuring the Bootloader Password The Bootloader password protects features, such as the MFP reset options that are available on the MFP control panel. These features are not commonly known, but they can severely affect the MFPs if they are executed improperly. The Bootloader password is not configured by default. CAUTION: Be very careful to remember the bootloader password that you provide. Once you configure the bootloader password, the bootloader features will be inaccessible permanently HP LaserJet and Color LaserJet MFP Security Checklist 20