HP A7518B HP StorageWorks SDLT Tape Drive Getting Started Guide - external mod - Page 19
Step 4: Attach power cable
UPC - 882780125599
View all HP A7518B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Step 4: Attach power cable An external HP StorageWorks SDLT 600 tape drive will operate using any voltage in the range 100-240 volts (0.7 A, 50-60 Hz). No adjustment is needed. To connect your tape drive to the power supply, proceed as follows: 1 Make sure that the tape drive is switched OFF. The power switch is on the rear panel. 2 Plug the power cable securely into the socket on the rear panel of the tape drive. (See Figure 6.) 3 Plug the other end of the power cable into the power outlet. 17
17
Step 4: Attach power cable
An external HP StorageWorks SDLT 600 tape drive will operate using any voltage in the range
100–240 volts (0.7 A, 50-60 Hz). No adjustment is needed. To connect your tape drive to the
power supply, proceed as follows:
1
Make sure that the tape drive is switched OFF. The power switch is on the rear panel.
2
Plug the power cable securely into the socket on the rear panel of the tape drive. (See Figure 6.)
3
Plug the other end of the power cable into the power outlet.