HP AD510A HP StorageWorks 1500 Modular Smart Array Installation Guide (355901- - Page 84
Installing the ACU-CLI on the servers (optional)
UPC - 829160218625
View all HP AD510A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
Configuration Procedures - HP-UX Environments Installing the ACU-CLI on the servers (optional) To use the ACU-CLI to configure MSA storage, perform the following steps to install it on the servers: Note: ■ You must remove earlier versions of the ACU before installing later versions. ■ For information about using the ACU-CLI, see ACU-CLI online help, the HP-UX ACU-CLI readme file or release notes, or the HP Configuring Arrays Reference Guide. 1. Insert the Support Software CD in the CD-ROM drive of the server. Note: If you created a new Support Software CD from the Web, insert that CD in the CD-ROM drive of the server and do not use the shipping version of the CD. For more information, see: ■ "Determine which version MSA controller firmware to use" on page 17 ■ "Obtain desired controller firmware and Support Software CD versions" on page 61 2. From the console, mount the CD-ROM drive and navigate to the /HPUXACUCLI/HP-UX directory for your environment. 3. List the contents of the directory and identify the ACU-CLI depot file for your environment. 4. Copy the ACU-CLI depot file and its corresponding readme file to a temporary directory on the server. For example: # cp /HPACUCLI/HP-UX/IA64/HPACUCLI_IA_v7.47-1.depot .tmp 5. Install the ACU-CLI application using the swinstall command. For example: # swinstall -s /tmp/HPACUCLI_IA_v7.47-1.depot 6. Remove the Support Software CD from the CD-ROM drive. Note: To start the ACU-CLI, do the following from the console: Navigate to the /opt/compaq/hpacucli/bld directory, and then enter # ./hpacucli. 84 HP StorageWorks 1500 Modular Smart Array Installation Guide