HP AM866A Brocade Fabric OS MIB Reference Guide v6.1.0 (53-1000602-02, June 20 - Page 905
connUnitControl 1.3.6.1.3.94.1.6.1.22, implementation-dependant online state. In general
UPC - 884420064602
View all HP AM866A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 905 highlights
connUnitControl 1.3.6.1.3.94.1.6.1.22 8 connUnitControl 1.3.6.1.3.94.1.6.1.22 Values Controls the addressed connUnit. Each implementation might choose not to allow any or all of these values on a SET. Cold start and warm start are as defined in MIB-II and are not meant to be a factory reset. This is similar to swAdmStatus: resetConnunitColdStart = reboot resetConnunitWarmStart = fastboot offlineConnUnit = disable switch onlineConnUnit = enable switch default after reboot = unknown The declaration 1 (unknown) maps to the default value upon rebooting, and 2 (invalid) is not applicable. Declarations 3 and 4 perform the same operation-a cold boot of the switch. Possible values are: • unknown (1) • invalid (2) • resetConnUnitColdStart (3): Reboot. Performs a switch reboot. • resetConnUnitWarmStart (4): Fastboot. The addressed unit performs a Warm Start reset. • offlineConnUnit (5): Disable switch. The addressed unit puts itself into an implementation-dependant offline state. In general, if a unit is in an offline state, it cannot be used to perform meaningful Fibre Channel work. • onlineConnUnit (6): Enable switch. The addressed unit puts itself into an implementation-dependant online state. In general, if a unit is in an online state, it is capable of performing meaningful Fibre Channel work. Fabric OS MIB Reference 889 53-1000602-02