HP BLc3000 HP BladeSystem Onboard Administrator User Guide - Page 9

server iLO, interconnect management processors such as Virtual Connect which use the Onboard Administrator/iLO management port Information and health status Yes. Complete control. reporting for all blades, interconnects, fans, power supplies, Onboard Administrators, and enclosure through Onboard Administrator's GUI or CLI, alert mail, or SNMP Insight Display Yes. Complete control. Enclosure DVD (requires either c3000 DVD option, external USB DVD drive, or USB key) Enclosure KVM (requires c3000 KVM option or Onboard Administrator module with VGA connector) Yes. Complete control. Yes. Complete control. such as Virtual Connect Administrator. Manager to other VC modules in the enclosure. No information is available Yes. Complete control, from the Onboard including sustaining a failure Administrator nor is any of either Onboard out-of-band information Administrator. available from VCM or iLO on any server. No. Yes. Complete control, including sustaining a failure of either Onboard Administrator. No. Yes. Complete control, including sustaining a failure of either Onboard Administrator. No. Yes. Complete control. For the HP c3000 Enclosure, requires both c3000 KVM option and redundant Onboard Administrator option. For the HP c7000 Enclosure, requires two of the newer Onboard Administrator modules with VGA connector. Stored Onboard Administrator settings and module replacement Enclosure model Single Onboard Administrator in enclosure Redundant Onboard Administrator (same replacement type installed)1 Redundant Onboard Administrator (different replacement type installed)1 c3000 c7000 All enclosure settings are lost All enclosure settings are When changing from the when a single module is retained on the remaining non-redundant c3000 removed and must be restored module and those settings are Onboard Administrator to manually using Insight Display synchronized to the replaced redundant Onboard and USB key, GUI, or CLI. module if the firmware Administrator with DDR2, the versions match.2 enclosure settings must be restored manually using Insight Display and USB key, GUI, or CLI. All enclosure settings are lost All enclosure settings are All enclosure settings are when a single module is retained on the remaining retained on the remaining removed and must be restored module and those settings are module and those settings are manually using Insight Display synchronized to the replaced synchronized to the replaced and USB key, GUI, or CLI. module if the firmware module if the firmware versions match.2 versions match.2 1 Removing a redundant Onboard Administrator module immediately results in the remaining module becoming the Active Onboard Administrator. Introduction 9