HP BladeSystem c3000 HP c3000 DDR2 Onboard Administrator Installation Instruct - Page 1

HP c3000 DDR2 Onboard Administrator Installation Instructions for HP BladeSystem c3000 and c3000 Tower Enclosure Introduction There are two optional Onboard Administrator modules available with the enclosure: • HP c3000 DDR2 Onboard Administrator module, part number 488099-B21 • HP c3000 Dual Onboard Administrator module, part number 488100-B21 To use the Onboard Administrator modules, you must have HP BladeSystem Onboard Administrator version 2.30 or greater installed. For more information on using the Onboard Administrator software, see the HP BladeSystem Onboard Administrator User Guide. You can install the optional HP c3000 DDR2 Onboard Administrator module in the enclosure without a second module. Before you install an HP c3000 Dual Onboard Administrator in the enclosure, you must have installed the c3000 DDR2 Onboard Administrator module. NOTE: The HP BladeSystem c3000 Enclosure is shown in the illustrations throughout this document. The HP BladeSystem c3000 Tower Enclosure is rotated 90 degrees clockwise from what is shown in the illustrations. HP c3000 DDR2 Onboard Administrator module components Item Name Description 4 Active Onboard An LED that Administrator LED indicates which Onboard Administrator is active 5 Health LED Green = OK Red = Critical error 6 USB A USB 2.0 Type A connector that connects supported USB devices 7 Reset button - HP c3000 Dual Onboard Administrator module components Upgrading an HP Onboard Administrator module to an HP c3000 DDR2 Onboard Administrator module 1. Disconnect all cables from the HP Onboard Administrator module. 2. Remove the HP Onboard Administrator module. 3. Slide either the c3000 Dual Onboard Administrator module (if ordered) or an Onboard Administrator blank into the c3000 DDR2 Onboard Administrator module, and close the handle. © Copyright 2008, 2009 Hewlett-Packard Development Company, L.P. The information contained herein is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for technical or editorial errors or omissions contained herein. Bluetooth is a trademark owned by its proprietor and used by HewlettPackard Company under license. Part Number 488456-002 September 2009 (Second Edition) Item 1 2 3 Item 1 2 3 Name Description Insight Display A display that provides information about 4 the health and operation of the enclosure 5 Serial connector Serial RS232 DB-9 connector with PC standard pinout. 6 UID LED Blue = UID on Dark = UID off Name Serial connector UID LED Active Onboard Administrator LED Health LED USB Reset button Description Serial RS232 DB-9 connector with PC standard pinout Blue = UID on Dark = UID off An LED that indicates which Onboard Administrator is active Green = OK Red = Critical error USB 2.0 Type A connector that connects supported USB devices -