HP BladeSystem c7000 HP BladeSystem Onboard Administrator User Guide - Page 161

Field DHCPv6 SLAAC Description Status of the IP address for all Onboard Administrator, interconnect, and server iLO modules in the enclosure from a DHCP server. Possible values are Enabled or Disabled. Status of auto configuration of IPv6 addresses from SLAAC messages to all Onboard Administrator, interconnect, and server iLO modules in the enclosure. Possible values are Enabled or Disabled. General Information Field MAC Address IP Address Subnet Mask Gateway DNS Server 1 DNS Server 2 Description The Onboard Administrator MAC address. This is an informational field and cannot be changed. Static IP address for the Onboard Administrator (required if static IP settings is selected) Subnet mask for the Onboard Administrator (required if static IP settings is selected) Gateway address for the Onboard Administrator (required if static IP settings is selected) The IP address for the primary DNS server The IP address for the secondary DNS server Onboard Administrator Name (DNS Host Name)-The name of the Onboard Administrator. The default for this field is the DNS host name. NIC Settings • Auto-Negotiate-Automatically configures the best link. This is the default setting. This option supports a NIC speed of 10Mb/s, 100Mbps, or 1000Mb/s. The 1000Mb/s setting is only available when Auto-Negotiate is selected. • Forced Full Duplex-Enables you to manually specify which settings the external NIC uses when trying to establish a link. The Onboard Administrator does not verify that the forced Ethernet settings are valid on the network. The loss of communications might occur if the wrong or incompatible settings are used. Forced settings take effect 3 seconds after enabling or disabling the settings. The forced option only supports NIC speeds of 10Mb/s or 100Mb/s. To modify the TCP/IP settings, select Click here. Standby Onboard Administrator Virtual Buttons tab Click Reset to reset the Onboard Administrator. A confirmation screen appears, asking if you are sure that you want to perform the action and that you are signed out and disconnected from the Onboard Administrator. Click OK to proceed, or click Cancel to exit without a change. Click Toggle On/Off to change the Onboard Administrator module UID light. This identifies a particular Onboard Administrator when there are more than one. Configuring the HP BladeSystem c7000 enclosure and enclosure devices 161