HP Brocade BladeSystem 4/24 Brocade Network Advisor SAN User Manual v11.1x (53 - Page 897

30 SNMP traps FIGURE 374 Add Trap Destination dialog box 4. Enter a general description of the trap destination in the Description field. 5. Enter the IP address of the trap destination in the IP Address field. This is a mandatory field. IPv4 and IPv6 addresses are accepted but a DNS name is not accepted. 6. Enter the SNMP trap listening port of the recipient in the Port # field. This is a mandatory field. Valid numeric values range from 1 through 65535. 7. Click the Enable check box to enable trap forwarding. 8. Click the Add Source Address check box. 9. Click the SNMP Trap Repeater check box. When enabled, all traps, whether the source is managed or unmanaged, are forwarded. When disabled, only traps from the selected products are forwarded. 10. Select the trap forwarding type from the list. Supported SNMP types are v1, v2c, and v3. 11. You can choose not to select a filter (zero), or you can select up to five filters from the Available Filters list. Click the right arrow button to move them to the Selected Filters list. 12. Click OK. Brocade Network Advisor SAN User Manual 853 53-1002167-01