HP CB472A HP 9250C Digital Sender - User Guide - Page 31
Jetdirect sub-menus continued, Table 2-3 - service manual
![]() |
View all HP CB472A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Table 2-3 Jetdirect sub-menus (continued) Menu item Sub-menu item Sub-menu item DHCPV6 Policy Primary DNS Manual Settings Proxy Server Diagnostics Proxy Port Embedded Test ENWW Values and Description Manual Settings: Use the Manual Settings menu to enable and manually configure a TCP/ IPv6 address in the format of 123.123.123.123. Router Specified: The stateful auto-configuration method to be used by the print server is determined by a router. The router specifies whether the print server obtains its address, its configuration information, or both from a DHCPv6 server. Router Unavailable: If a router is not available, the print server should attempt to obtain its stateful configuration from a DHCPv6 server. Always: Whether or not a router is available, the print server always attempts to obtain its stateful configuration from a DHCPv6 server. Use this item to specify an IPv6 address for a primary DNS server that the print server should use. Use this item to manually set IPv6 addresses on the print server. Enable: Select this item and choose On to enable manual configuration, or Off to disable manual configuration. Address: Use this item to type a 32-hexadecimal digit IPv6 node address that uses the colon hexadecimal syntax. Specifies the proxy server to be used by embedded applications in the device. A proxy server is typically used by network clients for Internet access. It caches Web pages, and provides a degree of Internet security, for those clients. To specify a proxy server, enter its IPv4 address or fully qualified domain name. The name can be up to 255 octets. For some networks, you might need to contact your internet service provider (ISP) for the proxy server address. Type the port number used by the proxy server for client support. The port number identifies the port reserved for proxy activity on your network, and can be a value from 0 to 65535. This menu provides tests to help diagnose network hardware or TCP/IP network connection problems. Embedded tests help to identify whether a network fault is internal or external to the device. Use an embedded test to check hardware and communication paths on the print server. After you select and enable a test and set the execution time, you must select Execute to initiate the test. Depending on the execution time, a selected test runs continuously until either the device is turned off, or an error occurs and a diagnostic page appears. Initial Setup menu 23
![](/manual_guide/products/hewlettpackard-9250c-hp-9250c-digital-sender-user-guide-f2c95e5/31.png)