HP Cisco MDS 9020 Cisco Nexus 5000 Series Release Notes Release 4.0(1a)N1(1a) - Page 8
Changes to the FCoE Model and Related Configuration, Virtual Interface Groups
View all HP Cisco MDS 9020 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Changes to the FCoE Model and Related Configuration Send documentation comments to [email protected] Changes to the FCoE Model and Related Configuration In the previous Cisco NX-OS 4.0(0)-based releases, the FCoE model allowed Ethernet and FCoE to co-exist on the interface. The virtual interfaces, virtual Ethernet and virtual Fibre Channel (VFC), did not affect each other. For example, if the virtual Ethernet interface was errdisabled, the VFC interface could still be up. With Cisco NX-OS Release 4.0(1a)N1(1), the CLI implementation was changed to provide forward compatibility with the forthcoming T11 FCoE Initialization Protocol (FIP). In this new FCoE model, the following is changed: • FCoE traffic is passed over Ethernet; the Ethernet STP controls port status. • FCoE traffic for a VSAN is transported over a single dedicated FCoE-enabled VLAN. Although the CLI implementation requires a VLAN-to-VSAN mapping, the FCoE frames are expected to be untagged or priority-tagged. The FCoE VLAN is not expected to be carried in the FCoE frames. This will change in a future release once FIP-based FCoE is supported. The changes to the virtual interfaces are described in the following topics: • Virtual Interface Groups, page 8 • Virtual Ethernet Interfaces, page 8 • Virtual Fibre Channel Interfaces, page 8 • VSAN-to-VLAN Mapping, page 9 Virtual Interface Groups In previous Cisco NX-OS 4.0(0)-based releases, a virtual interface group allowed you to bind virtual interfaces to a physical Ethernet interface, as shown in the following example: switch# configure terminal switch(config)# interface vig 1 switch(config-if)# bind interface ethernet 1/1 Virtual interface groups have been deprecated in release 4.0(1a)N1(1a). Virtual Ethernet Interfaces Cisco NX-OS Release 4.0(1a)N1(1a) does not support virtual Ethernet interfaces. All Ethernet features previously configured at the virtual Ethernet interface now need to be configured at the bound Ethernet interface. The following configuration statements must be explicitly configured on the Ethernet interface to keep behavior the same as virtual Ethernet interface: spanning-tree bpduguard enable spanning-tree port type edge trunk All other features (for example, ACLs, SPAN etc.) that were previously configured at the virtual Ethernet interface would need to be applied to the bound Ethernet interface. Virtual Fibre Channel Interfaces In previous Cisco NX-OS 4.0(0)-based releases, a virtual Fibre Channel interface was attached to a virtual interface group, which then bound it to the physical Ethernet interface. Cisco Nexus 5000 Series Release Notes, Release 4.0(1a)N1(1a) 8 OL-16601-01