HP Cisco MDS 9120 Cisco Nexus 5000 Series Release Notes, Release 4.0(1a)N1(1) - Page 14
Workaround, Symptom, ntp peer, VRF management, show interface
View all HP Cisco MDS 9120 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Caveats Send documentation comments to [email protected] Workaround: Use RADIUS for directed request authentication. • CSCsq76688 Symptom: The neighboring device for the Cisco Discovery Protocol (CDP) is not removed after shutting down the port for CDP hold time interval. Workaround: None. • CSCsl62545 Symptom: The fan LED on the Device Manager (DM) displays in amber color even though the fan is working properly. Workaround: None. • CSCsr28868 Symptom: When the Fibre Channel over Ethernet (FCoE) feature is disabled, any untagged Ethernet packet with 00 00 in the Ethertype/length field is treated as an invalid packet and is forwarded out with a bad Ethernet CRC. Workaround: None. • CSCsr35452 Symptom: When the ntp peer command is configured on the MDS fabric and is distributed using CFS, the Nexus 5000 Series switch appends an incorrect VRF name AC to the command instead of VRF management. Workaround: Use the ntp server command to synchronize time across the fabric. • CSCsr36661 Symptom: When IGMP group membership is statically configured with private VLAN (PVLAN) host ports, the hardware gets programmed correctly. However, the membership information is not programmed for PVLAN host ports after the switch is reloaded. Workaround: Delete and add the private VLAN association once again. • CSCsr64291 Symptom: When a port is congested due to traffic from multiple inputs, the traffic mapped to a user-defined QoS class can get discarded at a very slow rate (fewer frames per second) in spite of being configured with strict priority scheduling. Workaround: None. • CSCsr68690 Symptom: When an egress SPAN is configured on a port transmitting jumbo or large frames, the spanned frames are truncated to 2384 bytes. Workaround: None. • CSCsl21529 Symptom: An incorrect MTU value is displayed in the show interface command output. The Nexus 5000 Series switch only supports class-based MTU. Per-interface level MTU configuration is not supported. The switch supports jumbo frames by default. However, the show interface command output currently displays an incorrect MTU value of 1500 bytes. Workaround: None. • CSCsm03765 Symptom: The Set operation on the CISCO-IP-IF-MIB is not supported. You cannot set the mgmt0 IP address using SNMP. Cisco Nexus 5000 Series Release Notes, Release 4.0(1a)N1(1) 14 OL-16601-01