HP Cisco MDS 9124 Cisco MDS 9000 Family Release Notes for Cisco MDS NX-OS Rele - Page 28
Performing a Disruptive Upgrade on a Single Supervisor MDS Family Switch
View all HP Cisco MDS 9124 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Downgrading Your Cisco MDS SAN-OS Software Image Send documentation comments to mdsfeedback-doc.com. Performing a Disruptive Upgrade on a Single Supervisor MDS Family Switch Cisco MDS SAN-OS software upgrades are disruptive on the following single supervisor Cisco MDS Family switches: • MDS 9120 switch • MDS 9140 switch • MDS 9216i switch If you are performing an upgrade on one of those switches, you should follow the nondisruptive upgrade path shown in Table 10, even though the upgrade is disruptive. Following the nondisruptive upgrade path ensures that the binary startup configuration remains intact. If you do not follow the upgrade path, (for example, you upgrade directly from SAN-OS Release 2.1(2) or earlier version to NX-OS Release 4.1(x)), the binary startup configuration is deleted because it is not compatible with the new image, and the ASCII startup configuration file is applied when the switch comes up with the new upgraded image. When the ASCII startup configuration file is applied, there may be errors. Because of this, we recommend that you follow the nondisruptive upgrade path. Note You cannot upgrade an MDS 9120 switch or an MDS 9140 switch to Cisco NX-OS 4.x. See Table 3 for the list of switches that support Cisco NX-OS 4.x Downgrading Your Cisco MDS SAN-OS Software Image This section lists the guidelines recommended for downgrading your Cisco MDS SAN-OS software image and includes the following topics: • General Downgrading Guidelines, page 28 • Downgrading the SSI Image on Your SSM, page 32 General Downgrading Guidelines Use the following guidelines to nondisruptively downgrade your Cisco MDS NX-OS Release 4.1(3a): • Install and configure dual supervisor modules. • Issue the system no acl-adjacency-sharing execute command to disable acl adjacency usage on Generation 2 and Generation 1 modules. If this command fails, reduce the number of zones, IVR zones, TE ports, or a combination of these in the system and issue the command again. • Disable all features not supported by the downgrade release. Use the show incompatibility system downgrade-image command to determine what you need to disable. • Use the show install all impact downgrade-image command to determine if your downgrade will be nondisruptive. • Be aware that some features impact whether a downgrade is disruptive or nondisruptive: - Fibre Channel Ports: Traffic on Fibre Channel ports can be nondisruptively downgraded. See Table 12 for the nondisruptive downgrade path for all SAN-OS releases. - SSM: Intelligent services traffic on the SSM, such as SANTap, NASB, and FC write acceleration, is disrupted during a downgrade. SSM Fibre Channel traffic is not. Cisco MDS 9000 Family Release Notes for Cisco MDS NX-OS Release 4.1(3a) 28 OL-17675-05