HP Cisco MDS 9124 Cisco MDS 9000 Family Release Notes for Cisco MDS SAN-OS Rel - Page 17
Upgrading Your Cisco MDS SAN-OS, Software Image on Step 1
View all HP Cisco MDS 9124 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Upgrading Your Cisco MDS SAN-OS Software Image Send documentation comments to [email protected] Note To avoid any traffic disruption, modify the configuration of the SSM ports as described below, before upgrading a SAN-OS software image prior to Release 3.2(1a). For more information on upgrading SAN-OS software, see the "Upgrading Your Cisco MDS SAN-OS Software Image" section on page 10. If the configuration is not updated before the upgrade, the installation process for the new image will automatically convert all ports configured in auto mode to Fx mode. This change in mode might cause a disruption if the port is currently operating in E mode. To upgrade the image on your SSM without any traffic disruption, follow these steps: Step 1 Step 2 Step 3 Step 4 Verify the operational mode for each port on the SSM using the show interface command: switch# show interface fc 2/1 - 32 fc2/1 is up Hardware is Fibre Channel, SFP is short wave laser w/o OFC (SN) Port WWN is 20:4b:00:0d:ec:09:3c:00 Admin port mode is auto