HP Cisco MDS 9140 Cisco Nexus 5000 Series Release Notes, Release 4.0(1a)N1(1) - Page 18
Resolved Caveats-Cisco NX-OS Release 4.0(0)N1(2a
View all HP Cisco MDS 9140 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Caveats Send documentation comments to [email protected] • CSCsv30392 Symptom: The Cisco Nexus 5020 switch has a Pktmgr memory leak in version 4.0(0)N1(2). This causes STP to stop functioning after awhile causing a Layer 2 Loop. After breaking the redundant connections, the switch is unable to be managed, due to a No buffer space available message. Condition: The Cisco Nexus 5020 switch is setup in a triangle topology with two 6500 switches. Code version 4.0(0)N1(2) is loaded on the the Cisco Nexus 5020 switch. The redundant link had to be shut down in order to stop the loop. Workaround: To fix the broken state, do not configure SVI. • CSCso99821 Symptom: If PVLANs are created and deleted continuously and without pausing, the Ethernet interface may not be configurable and you have to reboot. Workaround: Pause between the creation and deletion of PVLANs and do not perform multiple PVLAN operations at the same time. Alternately, you can create a PVLAN before any PVLAN interface is created and remove the switch port PVLAN from the interface before the PVLAN is deleted. • CSCsr52118 Symptom: When you perform delete, add, shutdown or no shutdown operations on a VLAN, the port channel interface may lose VLAN membership in the forwarding plane. As a result, ports will not participate in any of the forwarding operations on that VLAN. This behavior applies to access port channels where the switch port access VLAN configuration matches the deleted and re-added VLAN. This behavior can occur for trunk port channels, if the deleted or re-added VLAN matches the native VLAN of the port channel. Workaround: Enter the shutdown command or the no shutdown command on the port channel. • CSCsr39670 Symptom: Although SNMP notification is enabled on the switch, traps for the power supply and fan modules are not received. Workaround: None. • CSCsr47531 Symptom: When a VSAN is configured as SPAN source, traffic from all the member ports is spanned to the SPAN destination port. When a switch is rebooted, the VSAN SPAN source remains in the down state. Workaround: Delete and add the VSAN sources for the SPAN session. Resolved Caveats-Cisco NX-OS Release 4.0(0)N1(2a) • CSCsu08988 Symptom: Telnet access is available only after reloading the Nexus 5020 switch with the no telnet server enable command running. Workaround: Execute the no telnet server enable command once again after reload even if the command is saved in the startup-config. Additionally, you can also apply filters to the SVI to allow only trusted hosts to communicate with the system. Cisco Nexus 5000 Series Release Notes, Release 4.0(1a)N1(1) 18 OL-16601-01